FAQ 22

Home
MC10000 FAQ
Update FAQ
Digitizer FAQ

Need help right now? Click here.

I used EasyEdit to print a template for my design, and used the Clothsetter to hoop the fabric. When it stitched out, the design was off more than 1/4". Why did this happen?

This can happen under the following conditions:

	The design in question is not centered.
	The design is sent to the MC10000 using a program other than *EasyEdit*.
	The template used with the Clothsetter is printed from *EasyEdit*.

The reason for the problem is that EasyEdit always centers each design that it imports. In cases where the design is not centered, this causes the template to be incorrect, unless the design is sent to the 10000 from EasyEdit. To prevent the problem, always send the design to the machine or PC Card using the same program that printed the template.

[Home] [MC10000 FAQ] [Update FAQ] [Digitizer FAQ]